Home > Tenax Blades > Ceramic Porcelain Blades
Sintered Material Blades From Tenax

Sintered Material Fabrication Blades

You know that fabricators that work a variety of sintered surfaces need to have blades engineered to cut various materials. Additionally, the blades themselves need to be able to perform in just the right way for it to effective. Tenax has developed a new group of products designed to help fabricators get the right blades for all sorts of materials; including sintered material such as ceramic & porcelain. You may be seeking other diamond blades. If so, you can check out our DEKTON blades or our quartz blades.

Ceramic Fabrication Blades

As you are aware, ceramic porcelain is an extremely hard material and it requires a blade that is designed to work effectively on these types of surfaces. Clean cutting is also important when it comes to working with ceramics and porcelain. Who wants a blade that cuts fast but not clean? Yet cutting clean but slow can cost you time and productivity; decreasing your profit. After all, time is money. Tenax ceramic blades are designed to give you the right porcelain blade that performs well on ceramic porcelain surfaces.

A number of companies produce ceramic and porcelain materials. That's why the Tenax ceramic blades have been engineered to perform well for cutting ceramic and porcelain surfaces. Our cycle of product development includes a series of iterative steps to construct products that are well-suited for their intended purpose. These Tenax ceramic blades are no exception to our research, design, and production process.

Small Porcelain Blades

Tenax offers 4 and 5 inch porcelain blades for use on cutting ceramic tiles. These small diamond blades are designed for dry cutting ceramic porcelain materials.

Ceramic Porcelain Bridge Saw Blades

Our ceramic blades are available in the following diameters:

Tenax ceramic blades for sintered materials are specifically marketed towards cutting hard sintered materials like porcelain. Try these ceramic porcelain diamond blades and see the results of our methodical research and development process.

  • Diameters: 14", 16"
  • Wet Use
  • RPM: 1900-2500 Depending on blade diameter.
* Tenax recommends entering and exiting the cut at a reduced speed. The reduction should be 40-50%. For 45° cutting, the suggested speed reduction is 40%.
Sort By:
Page of 1